Losi LOSB9607 - Manual

LOSB9607 Lithium Charge Converter
Features:
• Extend the use of approved NiCd or NiMH chargers:
• Charges approved LiPo (3.7V nominal per cell) battery packs:
• Charges approved M1 (3.3V nominal per cell) battery packs:
• Small compact size
• Ease of use
Specifications:
• Input: Approved charger intended for NiCd or NiMH batteries listed below.
• Maximum current: 8.0A
• Maximum number of LiPo cells is 6
• Maximum number of M1 cells is 8
• Provides a charge of 90%
User Interface:
LED Displayed:
- 8 YELLOW LED’s indicate the estimated number of cells
ƒ 2 cells -> Only the 2nd LED turns on
ƒ 3 cells -> Only the 3rd LED turns on... thru
ƒ 8 cells -> Only the 8th LED will turn on
NOTE: The 1 st LED: reserved for future use
- 1 BLUE LED to indicate battery type selected
ƒ ON = M1 mode
ƒ OFF = LiPo mode
- 1 GREEN LED to indicate charge status
• Slow Flash = Standby or charging has finished
• ON = Ready to charge or charge in progress
• OFF = No charger found
• Quick Flash = Error: Overheated, charge time over limit (1.5 hour)
thermal sensor measured the MOSFET heat level above 80
degrees Celsius (which is 176 degrees Fahrenheit).
Lithium Charge Converter Page 1 of 6