Losi LOSB9605 - Manual (Page 6)

6. If required, you may adjust the charge current during the charge. Begin by
pressing and holding the “START” button. You will see the Charge Current
blinking and then, using the Increase/ Decrease buttons, raise or lower the
rate. Never exceed 1C (1 x Capacity) or fire may result.
For example, if your battery is 2400mAh, do not exceed 2.4A
7. When your battery is fully charged the charger will make a beeping sound.
Please disconnect the charger from the battery.
Balance Method:
1. Connect the charger to a 12V car battery or DC hobby grade power supply
(DC11–18V). Use reference item “B” from physical overview for location.
2. Connect the battery to be charged to the main discharge connector and to the
balance connector. Use reference items “I” and “J” from physical overview for
location.
Note: See separate diagram for balance connector connection.
3. The following display will be shown; confirm the Charging Current.
Press “START” and the mAh value being displayed will blink.
Using the Increase and Decrease select buttons, adjust Charge Current to the
desired value.
Press “START” when ready to proceed to select Voltage of the Battery
(number of cells).
Using the Increase and Decrease select buttons, set the Voltage of the
Battery (number of cells).
4. Press and HOLD the “START” button for several seconds; the charger will
beep and the display will change to the following:
On the display, the “S” is the Cell count you selected on the previous screen;
“R” is the Cell count the charger determined. If both values are the same,
pressing the “START” button will begin the charge. If you need to change the
Cell count, press the “STOP” button and return to the previous screen to make
changes.