Kontron NSC2U IP Network Server - Manual (Page 119)

Kontron IP Network Server NSC2U
December 2009 Product Guide, rev. 1.4
119
4. If the replacement board does not have these components pre-installed and you
are re-using components from the old server board, do the following:
a. Install the processor(s) and heat sink(s). For instructions, see
Section 3.4.5.3,
“Installing a New Processor” on page 45 .
b. Install all DIMMs. For instructions, see Section 3.4.3, “Installing DIMMs” on
page 41 .
c. Install any I/O expansion modules or remote management modules. For
instructions see Section 4.3, “Installing an I/O Expansion Module” on page 55 or
Section 4.4, “Installing Intel® Remote Management Modules” on page 57 .
5. Install the PCI riser assembly. For instructions, see Table 4.2.5, “Replacing the
Riser Card Assembly on the Server Board” on page 55 .
Figure 104. Installing the Server Board
l
A
TS000537
C
B