Kontron NSC2U IP Network Server - Manual (Page 118)

NSC2U Server—5
Kontron IP Network Server NSC2U
Product Guide, rev. 1.4 December 2009
118
5.6.2 Installing the Server Board Back into the Chassis
1. Set the replacement board into place ( Figure 104 , “A”), using caution to make sure
no cables are pinched under the board. Insert the rear edge of the board first, and
line up the I/O ports at the rear of the system.
2. When placing the board into the chassis, make certain that the board does not
catch on the fan alignment bracket (“B”). Note the that bracket must reside under
the insulator.
3. Make sure the standoff locations line up correctly and reinsert the six screws
removed previously. (“C”)
Figure 103. Removing the Server Board
A
B
TS000570