Kontron KTLX800-pITX - Manual (Page 20)

KTD-S0022-C Page 15 Graphics Interface
KTLX800/pITX User's Guide
Note: 1) To protect the external power lines of peripheral devices make sure that
he maximum available current.
-protecting conditions of IEC/EN 60950.
- the wires have the right diameter to withstand t
- to enclosure of the peripheral device fulfills the fire
Warning: Check jumper J1600 (Panel Power) for correct settings for your panel – not doing so might cause permanent damage to
your panel.
7.3 Connecting a Flat Panel
To flat panel is supported check the TRON web site.
If you use one onfig n is eas
❶ r you ha the corr apter an o use. Inspect
damages. Disconnect the power fro
❷ the correct panel voltage ( Pos. 3.3V 2-3 = +5V ).
❸ supply for the correc +5V).
❹ Connect the cable to the flat panel connector nd connect the
other end to your disp .
❺ Supply power to your system. Enter the BIOS Se Only' at menu
'Advanced Settings/D ig n/Boot Display Dev n addition set the desired
display resolution at ' t Panel Ty
❻ If you still do not see improvement consider contacting the or technical support.
Note:
Display Cable Guide on the KON determine whether your
of the KONTRON adapters c
Check whethe
the cable for
Check the jumper J1600 for
Connect an external power
uratio y:
ve ect ad d cable for the panel you plan t
m your system.
1-2 = +
t backlight voltage (exception:
J1601 on the KTLX800/pITX a
lay
tup and choose the option 'LCD
ice' and i isplay Conf uratio
Fla pe'.
dealer f
For many flat panels with digital e the LDI color mapping should be selected although the displays are FPDI types.
The combination of the onboar S transmit adapter KAB-ADAPT-LVDStoTTL might require this setting.
interfac
d LVD ter and the
7.4 Flat Panel Voltage Jumper