Kontron KTLX800-pITX - Manual (Page 34)

KTD-S0022-C Page 29 LPC Bus
KTLX800/pITX User's Guide
The LPC bus (L
14 LPC Bus
ow Pin Co sed to ect h devices to the compagnion chip. This bus is
replacing the 16 bit-wide, 8 3 MHz ISA b with a ide bus op times the clock speed (33
MHz PCI bus clock freq y). The implementation ed on I ace specification V1.0,
external bus
You can use the LPC bu
d the board functio (e.g. Lat roller (LPC peripheral),
ROM emulator, TPM (T
unt) is u conn low bandwit
.3 us 4 bit-w erating at 4
® uenc
master are not supported.
s to expan
is bas ntel's LPC interf
nality tice LPC bus cont
rusted Platform Mod or LPC bridge). ule) to SPI
CA ! UTION
Do not use signal voltages abov LPC bu e 3.3V. s signals are
unprotect gains vervolta ed a t o ge.
1
T
4.1 Connector
he LPC bus interface is available through the connector J1505 (10 pins).
Header Pin Signal Name Function
VCC 1) 1 Power +3.3V
2 /RESET Reset
3 LCLK Clock
4 /LFRAME Start or stop transfer
5 LAD0 Address or data 0
6 LAD1 Address or data 1
7 LAD2 Address or data 2
8 LAD3 Address or data 3
9 SERIRQ Serial interrupt
1
GND 10 Ground
Note: 1) To protect the external power lines of peripheral devices make sure that
- the wires have the right diameter to withstand the maximum available current.
- to enclosure of the peripheral device fulfills the fire-protecting conditions of IEC/EN 60950.