beautypg.com

5getting started, Syst – Kontron KTLX800-pITX User Manual

Page 17

background image

KTD-S0022-C

Page 12

Getting Started

KTLX800/pITX User's Guide

5

Getting Started

Getting started with the KTLX800/pITX is simple. Take the following steps:

ry module into the RAM socket.

Connect a DVI monitor (analog input) to the CRT connector.
Plug a keyboard and/or mouse to the USB connector(s).

o the

KTLX800/pITX power supply connector.

front

Enter the BIOS by pressing the Del key during boot-up. Make all changes in the BIOS Setup.
See the BIOS Setup chapter of this manual for details.


6

em Memory

The KT

00

Plug a suitable DDR-SDRAM memo



Attach a harddisk to the S-ATA connector.

Make sure all your connections have been made correctly. Connect the power supply t

Turn on the board by shortening the power button pins with a push button on the power
panel header (J1506) or use the autostart jumper (J1301).

Syst

LX8 /pITX uses only 200 pin Small Outline Dual Inline Memory Modules (SODIMMs). One soc

+2.5V unbuffered DDR200 up to DDR333 SDRAM of up to 1 GB.

ount of memory available on the SDRAM module is used for main memory and graphi

ket is

available for
The total am

c memory

on the KTLX800/pITX. Shared Memory Architecture (SMA) manages the sharing of the system memory

etween graphic controller and processor. Therefore the full memory size is not available for software

applications.

b

Attention:

If you use the ACPI power mode S3 (Suspend to RAM) the DDR-SDRAM speed setting in the Bios Setup must be identical

with the nominal speed of the RAM module or select the 'Auto' setting - otherwise the System Bios crashes during the

resume sequence.

DDR400, DDR433 or DDR466 modules can only be operated with the DDR333 timing.




This manual is related to the following products: