Elecraft KXPA100 Assembly Manual User Manual

Page 12

Secure the ATU module pc board to the four standoffs using the screws and lock washers you removed

earlier as shown in Figure 8. Note that there is a hole near the center of the ATU module that is not used.

Figure 8. Securing the ATU Module to the Standoffs.

Press the black switch caps on the

MODE

and

TUNE

switches next to the LEDs on the ATU module (see

Figure 9). Do not press hard. They are a simple friction fit.

Figure 9. Installing the

MODE

and

TUNE

Switch Caps