Elecraft KX3 Programmers Reference - Manual (Page 25)

25
Appendix A: Change History [Applicable MCU revisions shown in brackets]
Note: Prior to revision D1 this document applied only to the K3. For earlier change history, see rev C14.
D1, 1-18-2012 [K3, rev 4.48; KX3, rev 0.58]
§ Document now pertains to both the K3 and KX3. Asterisks in Table 1 now show K3 commands that are not
functionally applicable to the KX3. (For K2 commands, refer to the KIO2 Programmer’s Reference.)
§ SWT/SWH, MN, and OM descriptions updated to show differences between K3 and KX3.
D2, 1-19-2012 [K3, rev 4.48; KX3, rev 0.59]
§ KXAT3 menu entry back to MN023.
§ XMIT/TUNE switch on KX3 remapped to match the K3’s SWT/SWH code (13). This allows KX3
Utility’s TX GAIN cal function work without being rewritten.
D5, 3-20-2012 [K3, rev 4.48; KX3, rev 0.80]
§ DB command is different for the KX3.
§ RG response is different for the KX3.
§ MQ command added for the KX3 (16-bit menu parameter access)
§ SPG command added (KX3 ground-reference check).
§ SMH command added (K3 high-resolution S-meter; to be added to the KX3 later)
D8, 4-5-2012 [K3, rev 4.48; KX3, rev 0.91]
§ PO command added (reads actual power output during transmit).
§ EL command added (turns run-time error logging on/off). Error logging, when ON, reports “ERR xxx” and
other events to the attached PC, unsolicited.
D9, 4-12-2012 [K3, rev 4.48; KX3, rev 0.92]
§ Added RX SHFT menu entry to KX3’s MN command ID list.
D10, 4-17-2012 [K3, rev 4.48; KX3, rev 0.92]
§ Corrected NL command description, including note about the KX3 noise blanker, which does not yet use
the NL command.
E2, 5-7-2012 [K3, rev 4.50; KX3, rev 0.99]
§ [KX3] The MN command table now reflects all of the KX3 menu parameters accessible via MP and MQ.
§ [KX3] The MP command now has a full list of menu entries for which the MP get/set parameters reference
only a subset of the 8 bits. Semantics and examples for these parameters are provided.
E3, 7-12-2012 [K3, rev 4.51; KX3, rev 1.10]
§ [KX3] Added RX NR to MN table.
E4, 9-18-2012 [K3, rev 4.51; KX3, rev 1.20]
§
[KX3] Added internal-only commands BC and KT to command table (documented elsewhere).