Elecraft KX3 Programmers Reference - Manual (Page 15)

15
sets both main and sub mode to n. (2) DATA and DATA-REV select the data sub-mode that was last in effect on
the present band. (To read/set data sub-mode, use DT.) The norm/rev conditions for the K3’s data sub-modes are
handled in two pairs at present: DATA A/PSK D, and AFSK A/FSK D. E.g., if the radio is set up for DATA A
mode, alternating between MD6 and MD9 will cause both DATA A and PSK D to be set to the same
normal/reverse condition. In K2 command modes 1 and 3 (K21 and K23), the RSP message converts modes 6 and
7 (DATA and DATA-REV) to modes 1 and 2 (LSB and USB). This may be useful with existing software
applications that don't handle DATA modes correctly.
MG (Mic Gain; GET/SET)
SET/RSP format: MGxxx; where xxx is 000-060.
ML (Monitor Level; GET/SET)
SET/RSP format: MLxxx; where xxx is 000-060. Applies to current mode (CW sidetone, voice, or data). In voice
modes, applies to MON level, even if DVR monitor level is independent (MAIN:TX DVR).