Dynojet 250iP: Pit Installation Guide User Manual
Dynojet Equipment
This manual is related to the following products:
Table of contents
Document Outline
- Cover
- Copyright
- Table of Contents
- Warnings
- Specifications and Operating Requirements
- Installation
- Unpacking and Installing the Dyno
- Eddy Current Brake
- Pickup Card
- Carriage Plate and Tire Carriage
- Blower Mounts, Support Arm and Junction Box
- Routing Cables
- Battery Requirements
- Installing the Battery
- Accessing the CPI
- Routing the Control Panel, Pendant Cables, and RPM Cable
- Routing the High Pressure Blower Cables
- Routing the Power Carriage and Wheel Clamp Cables
- Routing the Eddy Current Brake, Battery, and Dyno Power Cables
- Routing the Pickup Card and Dyno Electronics Cables
- Routing the Air Pump Power, Air Fuel Sensor, and Dyno Electronics Power Cables
- Wiring the Breakout Board
- Final Adjustments and Tests
- Pit Covers
- Junction Box Cover, Cable Cover, and End Cap
- Zip Tube
- Accessories
- Control Panel Interface Operation
- Basic Dyno Operation
- Red Head Anchor Installation
- Power Requirements
- EEC Finger Guard and Door Safety Switch Installation
- Theta Controller
- Index