HP Netserver L Server series - Manual (Page 49)

Chapter 6 Troubleshooting
Message
Mouse error
Incorrect System
Configuration
Corrective Action
Keyboard error Check that the keyboard is connected to the correct
connector (not the mouse connector) at the rear of the
system.
Replace the keyboard. If the problem persists, contact
your HP support organization.
Check that the mouse is connected to the correct
connector (not the keyboard connector) at the rear of
the system.
Replace the mouse. If the problem persists, contact your
HP support organization.
Press the F2 key to run the Setup utility. Change settings
as required. Press theFlO function key to exit, and
answer "Yes" to save the changes.
No Error Messages Displayed
If a POST error is detected before video display starts, a beep error message may
be generated. If so, refer to the list of Beep Error Messages in Information
Assistant.
General Checks
1. All external cables and power cables are ^-mly plugged in.
2. The power outlet is working.
3. The computer and display are turned on. (The power-on indicator should
be illuminated.)
4. The display’s contrast and brightness settings are correct.
5. All internal cables are properly connected, and all boards are ^-mly seated.
6. Check that the system board is fully seated in the backplane slot and that
the retaining latches at the top of the system board are ^ly lowered.
7. Check that the CPU module is fully seated in the upper (primary) CPU
socket on the system board.
8. Check that the terminator board or second CPU module is ^ly seated in
the lower (secondary) CPU socket on the system board.
43