HP Netserver L Server series - Manual (Page 42)

Chapter 5 Installation in Rack (Optional)
When you have finished installing the HP NetServer LC II in the rack assembly,
return to the
HP NetServer Rack Installation Road Map.
Pedestal Removal
You must remove the anti-tip pedestal from the HP NetServer before you install it
in a rack assembly. You may also need to remove it to facilitate shipping the HP
NetServer. To remove the pedestal, first remove the HP NetServer covers, and
then detach the pedestal and lift the HP NetServer off it, as described in "Remove
Covers" and "Remove Pedestal" below. After the pedestal is removed, do one of
the following:
• Mount the HP NetServer in a rack assembly, as instructed in the
documentation supplied in the rack mount kit and in the HP NetServer
RackAssembly and CablingReference Guide.
• Before packing the HP NetServer for shipping, replace all covers and the
front bezel, as described in "Replace All Covers and Connect All Cables"
in Chapter 1, "Installation Overview."
Remove Covers
1. Turn off the HP NetServer, and disconnect the power cord and all other
cables.
2. Remove the front bezel, top cover, and one or both side covers, as
described in Chapter 1: "Installation Overview."
Remove Pedestal
1. Depress the two plastic buttons that protrude through the metal base plate
of the HP NetServer, as shown in Figure 5-1.
36