HP Netserver L Server series User Manual

Page 13

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Text mode
Original mode

Chapter 1

Installation Overview

Lay the system board component-side up on a static-dissipating work surface with
the metal cross piece on the top rear corner of the system board extending off the
work surface, as shown in Figure 1-3.

Crosspiece must be OFF work surface.

System Board

Figure 1-3. Insert the DIMM

CAUTION Only install DIMMs on a system board lying ^at on a static-

dissipating work surface. The metal crosspiece indicated by

the arrow in Figure 1-3 must be OFF the work surface.

Otherwise, flexing can damage the system board.