HP Netserver L Server series - Manual (Page 25)

Chapter 2 HP Navigator
0 Select No for manual NOS installation. Perform a manual NOS
installation if you are installing a NOS other than certain versions of
Novell NetWare / IntranetWare or Microso^ Windows NT Server, or if
you have replaced any HP components.
• View Configuration Advisories: Read the con^guration advisories, and
print them out if necessary. You can change your hardware at this time to
conform to the advisories.
• Configure Remote Management: This utility con^gures the Integrated
Remote Assistant device for improved remote management. It enables
remote, dial-up server management. To con^gure Integrated Remote
Assistant, select Configure Remote Management on the Con^gure
Remote Management screen.
• Show System Information: Use this screen to display information about
standard and accessory boards and devices in the system, as well as the
used and available system resources.
0 Select View System Information on the Show System Information
screen to display information about standard and accessory boards and
devices in the system.
0 Select View Resources on the Show System Information screen to
display used and available system resources, such as memory ranges,
I/O port ranges, DMA channels, and interrupt (IRQ) levels.
• Configure Disk Array: If you have an HP disk array, you must con^gure
it with the disk array utility. Select Execute on the Con^gure Disk Array
screen to start the disk array utility.
• Install Utility Partition: This step creates an 8 MB utility partition on the
server hard disk where HP Navigator will copy Diagnostic Assistant, the
BIOS update utility, the event log report utility, the disk array utility, the
NIC con^guration utility, the Remote Assistant utilities, troubleshooting
utilities, and other utilities. It is not available for SCO UNIX. Select
Execute on the Install Utility Partition screen.
• Execute Card Utilities: When Con^guration Assistant detects installed
boards for which there are additional con^guration utilities on the HP
Navigator CD-ROM, you can execute these utilities to complete the
con^guration of the boards by selecting Execute on the Execute Card
Utilities screen.
1 9