Install additional memory, Remove the system board – HP Netserver L Server series User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Chapter 1
Installation Overview
5. If you are installing any accessory boards or additional mass storage
devices (other than hot swap disk drive modules), also remove the side
cover farthest from the system board:
a. Grasp the two tabs at the top of the side cover.
b. Pull upward and outward to lift the side cover off.
CAUTION Handle the side cover only by its top and bottom edges to
avoid damaging the EMI spring Angers inside its side edges.
Install Additional Memory
CAUTION Use only DIMMs acquired from HP. Refer to the following for
a list of qualified DIMMs:
• Technical Reference Label inside the HP NetServer top
cover
• HP Order Assistant on the HP Web Site at
• Information Assistant on the HP Navigator CD-ROM
• HP Customer Service
When handling DIMMs, observe antistatic precautions to
avoid damage.
Remove the System Board
If you are adding additional memory, remove the system board ^st. Use the
retaining latches to start lining the system board. Grasp the metal bracket at the
top of the system board, and li^ the system board straight up and out of the HP
NetServer, as shown in Figure 1-2