HP Netserver L Server series - Manual (Page 20)

Chapter 1 Installation Overview
3. Use the arrow keys to move the cursor, press ENTER to select an option,
and press ESC to exit. For more details, including default settings, refer to
Information Assistant.
Reserve Resources for ISA Non-Plug-and-Play Board
If you have installed an ISA non-Plug-and Play accessory board, you must reserve
system resources for it. Turn on the monitor and the HP NetServer, and start the
Setup utility by pressing the F2 key when
Press to enter SETUP
appears on the boot screen.
NOTE Pressing the F2 key when prompted should start the Setup
utility. For some ISA boards, the Setup utility will not start, and
you must remove the ISA board, use the Setup utility to reserve
system resources for the ISA board, and reinstall the ISA
board.
Use the Setup utility to allocate system resources to the ISA non-Plug-and-Play
accessory board. Refer to the "Installing ISA Non-Plug-and-Play Boards" in
Chapter 4, "Accessories," for instructions.
Run Configuration Assistant and Installation Assistant
Turn on the monitor and the HP NetServer, and insert the HP Navigator CD-ROM
into the drive. Turn the power off, wait 10 seconds, and turn the power on again. If
the system fails to start, follow the instructions on the screen.
1. When HP Navigator starts, you may need to set the language and the time
and date. Follow the onscreen instructions. You can also change the
language of the BIOS when prompted.
2. Go to the HP Navigator Main Menu and select “Con^guration and
Installation Assistant."
3. Follow the onscreen instructions in Con^guration Assistant to continue
your HP NetServer installation. For details, refer to the HP NetServer LCII
Installation Road Map, to Chapter 2, "HP Navigator," in this guide, and to
Information Assistant.
14