Install additional mass storage devices, Replace all covers and connect all cables – HP Netserver L Server series User Manual
Page 17
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Chapter 1
Installation Overview
e. Configuration Advisor displays the Configuration Advisories. You can
print them out by saving them to disk (diskette) and later printing out
from the diskette.
Read the documentation supplied with the accessory boards. If you are installing
an fSA non-Plug-and-Play board, write down the switch andjumper settings and
all system resource requirements (such as memory range, I/O port range, DMA
channel, and IRQ level). Refer to these notes when you allocate system resources
to the fSA non-Plug-and-Play board when you configure the HP NetServer.
Install Additional Mass Storage Devices
Certain mass storage configurations may require additional cables or adapters. For
part numbers for HP cables, adapters, and trays, and configuration information,
see Information Assistant on the HP Navigator CD-ROM. For new products, you
can use Order Assistant on the HP Web Site at
Replace All Covers and Connect All Cables
Refer to Figure 1-6 and replace all covers.
CAUTION Replace ALL covers before operating the HP NetServer, even
for a short time. Otherwise, overheating can damage
processors, boards, and mass storage devices.
1 1