HP Netserver L Server series - Manual (Page 37)

4 Accessories
Installing Accessories
If you are installing an ISA non-Plug-and-Play accessory board, follow the
directions in the
HP NetServer LC lUnstaUation Road Map. If it is not available,
refer to Information Assistant. Refer to "Con^guring ISA Non-Plug-and-Play
Board" in this chapter to reserve system resources for the board.
If you are installing additional memory (DIMMs), PCI accessory boards, or SCSI
mass storage devices follow the instructions in the
HP NetServer LC lllnstaUation
Road Map. If it is not available, refer to Information Assistant.
The backplane in the HP NetServer LC II has ^ve PCI slots and one combined
ISA/PCI slot for accessory boards. They are numbered 1-6 ^om left to right, as
viewed from the rear of the HP NetServer.
• Slot 1 is the combined ISA/PCI slot.
• An optional disk array controller board (DAC) may be preinstalled in
Slot 5.
• Slot 6 contains a network interface controller board (NIC).
The HP NetServer LC II chassis contains either three or six mass-storage shelves,
depending on the model. They are numbered ^om top to bottom.
• Shelf 1 contains a ^exible disk drive.
• Shelf 2 contains an IDE CD-ROM drive.
• Shelf 3 may contain an optional SCSI hard disk drive.
• An optional hot swap subsystem may occupy Shelves 4-6. It can hold up to
three hot swap disk drive modules.
The remaining shelves can be used to install 3.5" or 5.25" SCSI mass storage
devices.
3 1