Common installation problems, If the system will not power on – HP Netserver L Server series User Manual
Page 46
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Chapter 6
Troubleshooting
0 Diskette Library: Enables you to conveniently generate any flexible
diskette available on the HP Navigator CD-ROM. For example, you
can create the following diskettes: BIOS Update, NOS Drivers, and
Diagnostic Assistant.
• For problems with hard disk drives, refer to the
HP NetServer Hard Disk
Drive Troubleshooting Guide.
•
For problems with integrated Remote Assistant, refer to the
HP NetServer
LC HRemote Administrator Guide
or information Assistant.
• For problems with the network interface controller board (NiC), refer to its
documentation in information Assistant.
• For problems with the disk array controller board (DAC), if you have one,
refer to the
HP NetRAID Series User Guidefor HP NetRAID and HP
NetRAID-1
in information Assistant.
• For problems with HP TopTools, refer to the
TopTools Administrator
Guide
on the HP Web Site at
Common Installation Problems
The following sections contain general procedures to help you locate installation
problems. if you need assistance, contact your reseller first. if you need to get
assistance from Hewlett-Packard, refer to Appendix D for information on service
and support.
If the System Will Not Power On
Follow these steps if the power/activity light does not light green after you press
the power-on button:
1. Check to ensure that all cables and power cords are firmly plugged into
their proper receptacles.
2. if the HP NetServer is plugged into a switched multiple-outlet box, make
sure the switch on the outlet box is turned on.
3. Plug a different electrical device (such as a printer) into the power outlet,
and turn it on to check if the fault is with the power supply.
4. Unplug the power cord, wait 20 seconds, plug the power cord in again, and
restart the system.
40