HP Netserver L Server series - Manual (Page 41)

5 Installation in Rack (Optional)
Rack Installation Overview
Before you install the HP NetServer in a rack assembly, install any optional
hardware in the HP NetServer. You can con^gure the HP NetServer before or
after you install it in the rack. Before you start, read the rack installation kit
instructions. Also refer to the
HP NetServer RackAssembly and Cabling
Reference Guide.
Before you install the HP NetServer in a rack assembly, prepare the rack
enclosure, as follows:
• Assemble the rack enclosure(s).
• Tie together any multiple rack enclosures.
• Plan all units in the rack enclosure.
• Install the power distribution unit (PDU), fan, ballast, and any
uninterruptible power supply (UPS) in the rack enclosure.
• Install all units in the rack enclosure that are lower than the HP NetServer
LC Il's position.
• Install the base assembly that will hold the HP NetServer LC II, as
described in the rack installation kit instructions. The HP NetServer Rack
Assembly and Cabling Reference Guide may contain additional
instructions.
• Ensure that the anti-tip foot of the rack enclosure is extended.
Remove the ^ont bezel and all covers ^om the HP NetServer LC II. If the HP
NetServer is mounted on an anti-tip pedestal, refer to "Pedestal Removal," and
remove it.
Place the HP NetServer on the base assembly in the rack enclosure, as described in
the rack installation kit instructions. The
HP NetServer RackAssembly and
Cabling Reference Guide may contain additional instructions. Screw the HP
NetServer to the base assembly, replace the front bezel and all covers on the HP
NetServer, and attach all ^ller panels, as described in the rack installation kit
instructions.
35