Dell Latitude CPx H - Manual (Page 26)

Click the Start button, point to Settings, click Control Panel, and double-click the System
icon. The amount of memory installed in the computer is displayed in the lower-right corner
of the General tab window.
In the System Setup program, the System Memory option appears in the lower-right corner
of pages 1, 2, and 4.
To run the System Setup program, press on the computer’s keyboard (or Lock> on an external keyboard if the External Hot Key option is enabled).
If the total amount of memory shown is incorrect, the memory module(s) may not be installed
properly. Repeat
preparatory steps 1 through 4 and removal and installation steps 1 through 8
until the memory total is correct.
9. Run the System Memory test of the Dell Diagnostics to confirm that all installed memory modules are
operating correctly.
10. Use the Suspend-to-Disk utility to update the S2D partition on your hard-disk drive. The S2D partition
stores system data while the computer is in suspend-to-disk mode.
Back to Contents Page