Dell PowerEdge 1800 - Manual (Page 89)

Installing System Options
89
2 Replace the three screws to secure the control panel to the front of the system.
3 Place the control panel and chassis-intrusion switch cables in the cable retainer clip, remove
the cable slack between the clip and the control panel, and then close the clip. See Figure 6-8.
4 If you removed a 5.25-inch drive in step 4 of the previous procedure, reinstall the drive. If you
removed the chassis drive insert in step 4 of the previous procedure, reinstall the insert. See
"Installing the Front-Panel Drive Inserts" and "Installing a 5.25-Inch Drive" in
"Troubleshooting Your System."
5 If the system is a tower, stand the system upright.
6 Close the system. See "Closing the System" in "Troubleshooting Your System."
7 Reinstall the bezel. See "Installing the Bezel" in "Troubleshooting Your System."