beautypg.com

Dell DR4000 User Manual

Page 36

background image

36

About Your System

Warning! Power
required exceeds
PSU wattage.
Check PSU and
system
configuration.
Warning!
Performance
degraded. CPU and
memory set to
minimum
frequencies to
meet PSU wattage.
System will
reboot.

The system configuration of

processor(s), memory

modules, and expansion

cards may not be supported

by the power supplies.

If any system components

were just upgraded,

return the system to the

previous configuration. If

the system boots without

this warning, then the

replaced component(s) are

not supported with this

power supply. If Energy

Smart power supplies are

installed, replace them with

the High Output power

supplies to use the

components. See "Power

Supplies" on page 74.

Warning! PSU
mismatch. PSU
redundancy lost.
Check PSU.

A high output power supply

and an Energy Smart power

supply are installed in the

system at the same time.

Install two high output

or two Energy Smart power

supplies in the system.
You can also run the system

on one power supply until

you can obtain two power

supplies of the same type.

See "Troubleshooting Power

Supplies" on page 127.

Warning!
Unsupported
memory
configuration
detected. The
memory
configuration is
not optimal. The
recommended
memory
configuration
is:

Invalid memory

configuration. The system

runs but with reduced

functionality.

Ensure that the memory

modules are installed in a

valid configuration.

See "General Memory

Module

Installation Guidelines" on

page 76. If the

problem persists,

see "Troubleshooting System

Memory" on page 129.

Message

Causes

Corrective Actions

book.book Page 36 Friday, January 6, 2012 2:11 PM