Dell DR4000 - Manual (Page 25)

About Your System 25
BIOS Update
Attempt Failed! Remote BIOS update
attempt failed.
Retry the BIOS update.
If problem persists,
see "Getting Help" on
page 149.
Caution!
NVRAM_CLR jumper
is installed on
system board.
Please run SETUP. NVRAM_CLR jumper is
installed in the clear setting.
CMOS has been cleared.
Move the NVRAM_CLR
jumper to the default
position (pins 3 and 5).
See Figure 6-1 for jumper
location. Restart the system
and re-enter the BIOS
settings. See "Using the
System Setup Program and
UEFI Boot Manager" on
page 39.
CPU set to
minimum
frequency. The processor speed may be
intentionally set lower for
power conservation.
If not an intentional setting,
check any other system
messages for possible causes.
CPU x installed
with no memory. Memory modules are
required but not installed in
the indicated processor’s
memory slots.
Install memory modules for
the processor. See "System
Memory" on page 76.
Message Causes Corrective Actions
book.book Page 25 Friday, January 6, 2012 2:11 PM