Dell OptiPlex E1 - Manual (Page 50)

2-22 Dell OptiPlex E1 Mini Tower Managed PC Reference and Installation Guide
5HSODFH WKH FRPSXWHU FRYHU DQG WKHQ UHFRQQHFW WKH FRPSXWHU DQG
SHULSKHUDOV WR WKHLU HOHFWULFDO RXWOHWV DQG WXUQ WKHP RQ
Booting with the PSWD jumper installed reenables the password feature. When
you enter the System Setup program, both password options appear as Not
Enabled, meaning that the password feature is enabled but that no password has
been assigned.
NOTE: After you remove and replace the cover, the chassis intrusion detector will
cause the following message to be displayed at the next system start-up:
ALERT! Cover was previously removed.
7R UHVHW WKH FKDVVLV LQWUXVLRQ GHWHFWRU HQWHU WKH 6\VWHP 6HWXS SURJUDP
DQG UHVHW &KDVVLV ,QWUXVLRQ WR 1RW 'HWHFWHG
See “Chassis Intrusion” earlier in the chapter for instructions.
NOTE: If a setup password has been assigned by someone else, contact your
network administrator for information on resetting the chassis intrusion detector.
$VVLJQ D QHZ V\VWHP DQGRU VHWXS SDVVZRUG
To assign a new system password, see “Assigning a System Password” found
earlier in this chapter. To assign a new setup password, see “Assigning a Setup
Password” found earlier in this chapter.
5HVSRQGLQJWR(UURU0HVVDJHV
If an error message appears on your monitor screen while the system is booting,
make note of the message. Then, before entering the System Setup program, refer to
your
Diagnostics and Troubleshooting Guide for an explanation of the message and
suggestions for correcting any errors. However, it is normal to receive an error mes-
sage the first time you boot the system after a memory upgrade. In that case, you do
not need to refer to the
Diagnostics and Troubleshooting Guide; instead, refer to the
instructions in “Adding Memory” in Chapter 6 of this guide.
If you are given an option of pressing either to continue or to run the Sys-
tem Setup program, press the key.