Dell OptiPlex E1 - Manual (Page 133)

ISA Configuration Utility Messages B-7
ERROR: Failed NVS write.
Error=
Internal Error
Code.
An attempt to write to
NVRAM failed. Run the Dell Diagnostics to verify the
integrity of your system NVRAM. See the
chapter titled “Running the Dell Diagnos-
tics” in your
Diagnostics and Troubleshooting
Guide for instructions.
If you are unable to determine the cause of
the error, see the chapter titled “Getting
Help” in your
Diagnostics and Troubleshoot-
ing Guide for instructions.
ERROR: Failed to acti-
vate device, CSN=
Card
Select Number.
A Plug and Play expan-
sion card could not be
activated. Use the following procedure:
([LW WKH ,&8 DQG WXUQ RII \RXU
V\VWHP
5HPRYH WKH 3OXJ DQG 3OD\ H[SDQ
VLRQ FDUG WKDW FRXOG QRW EH
DFWLYDWHG
Follow steps 2 through 6 of “Remov-
ing an Expansion Card” in Chapter 6,
and then return to this procedure.
5HLQVWDOO WKH 3OXJ DQG 3OD\
H[SDQVLRQ FDUG
Follow steps 5 through 9 of “Installing
an Expansion Card” in Chapter 6, and
then return to this procedure.
If you still receive the error message, con-
tact the manufacturer of the Plug and Play
expansion card for assistance.
7DEOH % &RQILJXUDWLRQ 0DQDJHU 0HVVDJHV FRQWLQXHG
0HVVDJH 3UREDEOH &DXVH &RUUHFWLYH $FWLRQ
NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary in the online System User’s Guide.