Dell OptiPlex E1 - Manual (Page 47)

Using the System Setup Program 2-19
If you want to assign a new system password, follow the procedure in “Assigning a
System Password” found earlier in this chapter.
8VLQJWKH6HWXS3DVVZRUG)HDWXUH
Your Dell system is shipped to you without the setup password feature enabled. If
system security is a concern, you should operate your system with setup password
protection.
You can assign a setup password, as described in the next subsection, “Assigning a
Setup Password,” whenever you use the System Setup program. After a setup
password is assigned, only those who know the password have full use of the Sys-
tem Setup program.
To change an existing setup password, you must know the setup password (see
“Deleting or Changing an Existing Setup Password” found later in this chapter). If you
assign and later forget a setup password, you need to remove the computer cover to
change a jumper setting that disables the setup password feature (see “Disabling a
Forgotten Password” found later in this chapter). Note that you erase the
system
password at the same time.
$VVLJQLQJD6HWXS3DVVZRUG
A setup password can be assigned (or changed) only when the Setup Password
option is set to Not Enabled. To assign a setup password, follow these steps:
(QWHU WKH 6\VWHP 6HWXS SURJUDP
+LJKOLJKW WKH 6\VWHP 6HFXULW\ RSWLRQ DQG SUHVV (QWHU!
+LJKOLJKW WKH 6HWXS 3DVVZRUG RSWLRQ DQG SUHVV (QWHU!
7\SH WKH GHVLUHG VHWXS SDVVZRUG LQ WKH (QWHU 3DVVZRUG ILHOG DQG SUHVV
(QWHU!
If a character is illegal for password use, the system emits a beep.
7\SH WKH GHVLUHG VHWXS SDVVZRUG LQ WKH &RQILUP 3DVVZRUG ILHOG DQG
SUHVV (QWHU!
The setup password is now assigned. The Setup Password option changes from
Not Enabled to Enabled.
NOTES: The setup password can be the same as the system password.
If the two passwords are different, the setup password can be used as an alternate
system password. However, the system password cannot be used in place of the
setup password.
After you verify the password, the Setup Password setting changes to Enabled. The
next time you enter the System Setup program, the system prompts you for the
setup password.