Dell OptiPlex E1 - Manual (Page 142)

C-6 Dell OptiPlex E1 Mini Tower Managed PC Reference and Installation Guide
&ODVV%,7(
This is a Class B product based on the standard of the Voluntary Control Council for
Interference (VCCI) for information technology equipment. If this equipment is used
near a radio or television receiver in a domestic environment, it may cause radio inter-
ference. Install and use the equipment according to the instruction manual.
)LJXUH & 9&&, &ODVV % ,7( 5HJXODWRU\ 0DUN
3ROLVK&HQWHUIRU7HVWLQJDQG&HUWLILFDWLRQ
1RWLFH
The equipment should draw power from a socket with an attached protection circuit (a
three-prong socket). All equipment that works together (computer, monitor, printer,
and so on) should have the same power supply source.
The phasing conductor of the room’s electrical installation should have a reserve
short-circuit protection device in the form of a fuse with a nominal value no larger than
16 amperes (A).
To completely switch off the equipment, the power supply cable must be removed
from the power supply socket, which should be located near the equipment and easily
accessible.
A protection mark “B” confirms that the equipment is in compliance with the protec-
tion usage requirements of standards PN-93/T-42107 and PN-89/E-06251.