Dell OptiPlex E1 - Manual (Page 115)

Installing Drives 7-11
5HPRYH WKH GULYH EUDFNHW IURP WKH FKDVVLV
If a hard-disk drive is already installed in the drive bracket, disconnect the DC
power cable and EIDE cable from the drive.
Remove the screw securing the hard-disk drive bracket to the drive cage in the
chassis.
Grasp the bracket, and rotate it outward from the chassis until the sliding tab
clears the slide rail on the drive cage (see Figure 7-10). Lift the bracket up slightly
to free its hinge tabs from the chassis slots.
)LJXUH 5HPRYLQJ WKH +DUG'LVN 'ULYH %UDFNHW
6OLGH WKH GULYH LQWR WKH FKRVHQ ED\ RI WKH EUDFNHW RULHQWHG VR WKDW WKH
FRQQHFWRUV RQ WKH EDFN RI WKH GULYH ZLOO IDFH WKH EDFN RI WKH FKDVVLV
ZKHQ WKH EUDFNHW LV UHLQVWDOOHG VHH )LJXUH
$OLJQ WKH IRXU VFUHZ KROHV RI WKH GULYH DQG EUDFNHW ,QVHUW DQG WLJKWHQ
WKH VFUHZV WKDW FDPH ZLWK \RXU XSJUDGH NLW
If you are installing a drive in the 1.6-inch bay, use the four screw holes in the side
of the bracket (see Figure 7-11). If you are installing a drive in the 1-inch bay, use
the four screw holes in the bottom of the bracket.
sliding tab
hinge tabs
drive-cage slide rail
chassis slots