Dell OptiPlex E1 - Manual (Page 135)

ISA Configuration Utility Messages B-9
WARNING: Could not con-
figure
Plug and Play Card
Name.
WARNING: Could not con-
figure PCI device,
ID=
DeviceID.
Failed to configure Num-
ber of Total Count Plug
and Play ISA devices. Use
your system’s configura-
tion utility to resolve
conflicts. Press any key
to continue.
The card(s) mentioned
are not fully configured
due to resource conflicts. If you do not know the allowable resource
values for your Plug and Play or PCI expan-
sion card, use the following procedure to
locate and resolve the resource conflict:
5HPRYH DOO FDUG FRQILJXUDWLRQV
IURP WKH ,&8
See “Removing a Card” in Chapter 3
for instructions.
5HERRW \RXU V\VWHP
The ICU should automatically config-
ure your Plug and Play or PCI
expansion card.
$GG WKH ,6$ H[SDQVLRQ FDUGV
EDFN LQWR WKH ,&8 UHVROYLQJ DQ\
UHVRXUFH FRQIOLFWV DV WKH\ DULVH
See “Adding a Listed Card” in
Chapter 3 for instructions.
If your Plug and Play or PCI expansion card
is not automatically configured when you
reboot the system with all other cards
removed, you should contact the manufac-
turer of the card or see the chapter titled
“Getting Help” in your Diagnostics and
Troubleshooting Guide.
WARNING: Boot Device
conflict detected!
CSN=
Card Select Number
Error= Error.
One of the devices is
attempting to use one or
more resources assigned
to the system’s boot
device. Perform the following procedure:
6WDUW WKH ,&8
,GHQWLI\ WKH FDUG PDUNHG
config
err
This card is attempting to use one or
more resources required by the sys-
tem’s boot device.
)ROORZ WKH SURFHGXUH IRU WKH SUH
FHGLQJ HUURU PHVVDJH LQ WKLV
WDEOH
7DEOH % &RQILJXUDWLRQ 0DQDJHU 0HVVDJHV FRQWLQXHG
0HVVDJH 3UREDEOH &DXVH &RUUHFWLYH $FWLRQ
NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary in the online System User’s Guide.