Opening and closing the system, Opening the system – Dell PowerEdge C6100 User Manual
Page 91
Installing System Components
91
7 Connect the hard drive and power cables to the system board.
8 If applicable, install the SAS mezzanine card or the Infniband mezzanine
card. See "Installing the SAS Mezzanine Card" on page 75 or "Installing
the Infiniband Mezzanine Card" on page 77.
9 Install the expansion-card assembly. See "Installing the Expansion Card"
10 Replace the system-board assembly. See "Installing a System-Board
11 Reconnect the system to its electrical outlet and turn on the system,
including any attached peripherals.
Opening and Closing the System
WARNING:
Whenever you need to lift the system, get others to assist you.
To avoid injury, do not attempt to lift the system by yourself.
CAUTION:
This system must be operated with the system cover installed to
ensure proper cooling.
CAUTION:
Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came
with the product.
Opening the System
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Remove the securing screw from the system cover. See Figure 3-22.
3 Press the cover release latch lock. See Figure 3-22.
4 Grasp cover on both the sides with your palm on the traction pad, slide out
and lift the cover away from the system. See Figure 3-22.
book.book Page 91 Thursday, March 4, 2010 4:38 PM