Dell PowerVault DR6000 - Manual (Page 12)

Item Indicator, Button, or
Connector
Icon Description
• To reset iDRAC (if not disabled in F2 iDRAC
setup), press and hold the button for more than
15 seconds.
2 System identification
connector Connects the optional system status indicator
assembly through the optional cable management
arm.
3 iDRAC7 Enterprise port Dedicated management port.
NOTE: The port is available for use only if the
iDRAC7 Enterprise license is installed on your
system.
4 PCIe expansion card
slots low-profile (3) Allows you to connect up to three PCI Express
expansion cards.
5 Serial connector Allows you to connect a serial device to the
system.
6 Video connector Allows you to connect a VGA display to the system.
7 USB connectors (2) Allows you to connect USB devices to the system.
The ports are USB 2.0-compliant.
8 Ethernet connectors Four integrated 10/100/1000 Mbps NIC
connectors
or
Four integrated connectors that include:
• Two 10/100/1000 Mbps NIC connectors
• Two 100 Mbps/1 Gbps/10 Gbps SFP+/
10GBASE-T connectors
9 PCIe expansion card
slots full height (3) Allows you to connect up to three full-height PCI
Express expansion cards.
10 Power supply (PSU1)
AC 1100 W
11 Power supply (PSU2)
AC 1100 W
12 Hard drives (2) (back) Two hot-swappable 2.5-inch hard drives.
13 vFlash media card slot Allows you to insert a vFlash media card.
NIC Indicator Codes
The following topic describes the NIC indicator codes of the Dell DR6000 system.
12