Baumer RXA1H - Manual (Page 6)

Manual_ProCam_V1-10_EN.doc 6/35 Baumer IVO GmbH & Co. KG
10.05.11 Villingen-Schwenningen, Germany
3 ProCam Program
3.1 Basics
The ProCam program is a software for programming Baumer IVO cam encoders. It can be
used to read out, change, program and display the encoder data. To make programming as
simple as possible, the user can select only the fields valid for the respective state. Fields
which cannot be selected in the current state have a gray background. Before the encoder can
be programmed, the encoder type must be selected. This results in a logical procedure
following the program start:
1. Step
Select language with country flags
2. Step Select encoder type with "Select encoder" button
3. Step Programming can be started
If your encoder is not automatically detected, or is not contained in the selection list, please
contact Baumer IVO.
3.2 Program procedure
After the Start screen has run, the following mask appears:
Programming cannot begin until an encoder type has been selected.
Encoder selection is described in the chapters "Encoder connected to PC
⇒ Automatic
selection" and "Select encoder type from table ⇒ Manual selection".