Baumer RXA1H - Manual (Page 15)

Manual_ProCam_V1-10_EN.doc 15/35 Baumer IVO GmbH & Co. KG
10.05.11 Villingen-Schwenningen, Germany
4.1.4 Info
With Info the version of the ProCam and encoder software can be displayed.
4.1.5 Reprogramming
The display mask is reset to the basic setting. The same function can also be run
with "File
⇒ New".
4.1.6 Open file
Programming stored in the PC can be loaded. The same function can also be run
with "File
⇒ Open".
4.1.7 Save file
The current data are saved in the PC. The same function can also be run with "File
⇒ Save".
4.1.8 Print
The current encoder data are printed out. The printout can be used for archiving.
The same function can also be run with "File
⇒ Print".
4.1.9 Request data from encoder
The data are requested from the connected encoder. The same function can also be
run with "Extras
⇒ Read data".
4.1.10 Send data to encoder (save)
The current programming is saved in the encoder. The same function can also be
run with "Extras
⇒ Send data".
4.1.11 Display position/activate cam program
The current position and the status of the special outputs are shown. The same
function can also be run with "Extras
⇒ Display position".