Edge Lighting Reveal, 24VDC Plaster-In LED System - Manual

1
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.purelighting.com
[email protected]
© 2013 Pure Lighting. All Rights Reserved.
SAVE THESE INSTRUCTIONS!
- Reveal channel can be used as a toe kick or for cove
lighting.
- This instruction shows a typical installation.
IMPORTANT INFORMATION
INS# 902-RV-24VDC-02
Install the Junction Box (C-1RE-JBOX)
1: Mount each adjustable mounting bar to one side of the
junction box (mounts to any side of the housing
depending on the orientation of the channel) and secure
them with the mounting brackets and two Phillips screws
provided.
A
Installation Instructions For
Reveal Light Channel
JUNCTION
BOX
MOUNTING
BRACKET
ADJUSTABLE
MOUNTING BAR
JUNCTION
BOX
ADJUSTABLE
MOUNTING BAR
STUD
#8 SCREW
PHILLIPS SCREW
JUNCTION
BOX
DRYWALL CUTOUT
TEMPLATE
PHILLIPS SCREW
VERTICAL
ORIENTATION
HORIZONTAL
ORIENTATION
CONDUIT
JUNCTION BOX
STUD
FROM REMOTE
POWER SUPPLY
1
2: Select the location between the two studs for the junction
box to be mounted.
3: Place the adjustable mounting bars between the studs.
4: Make sure the lips on the adjustable mounting bars are
against the studs. Secure the adjustable bars to the studs
with the eight #8 screws.
B
3 4
NOTE: The adjustable mounting bars mount to studs that
are spaced 14.5" to 24" apart.
5: Remove the two Phillips screws to pull the drywall cutout
template completely off the junction box face. Save the
template and screws (these screws will be reused for step
9 on page 2).
C
6: Remove a knockout on the junction box to install conduit
into the power feed electrical box.
7: Install the conduit and run the low voltage 24V DC power
wires.
D
5 6
7
2