Edge Lighting Lyra 120 - Manual

Installation Instructions for Lyra Suspension
904-LYRA-01
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
Install the Fixture
1
LYRA-_
© 2012 Edge Lighting. All Rights Reserved.
SAVE THESE INSTRUCTIONS!
- This product is ETL listed for indoor dry locations.
- This product is ceiling mounted only.
- This product can mount to either a 4" square electrical box
with round plaster ring or an octagon electrical box.
- Only the MR16 Lamps can be dimmed with a low voltage
electronic dimmer.
IMPORTANT INFORMATION
IMPORTANT SAFETY INSTRUCTIONS
To reduce the risk of fire, electrical shock, exposure to
excessive UV radiation, or injury to persons:
- Use this fixture indoors only.
- Do not look directly at the lamp while the fixture is on.
- RISK OF FIRE: Use only the type of lamp and maximum
wattage indicated in this instruction manual.
- Never cover the halogen lamp with anything other than a
lamp shade provided by Edge Lighting and never place
flammable material close to the fixture.
- Never turn the fixture on and off by connecting and
disconnecting the halogen lamp.
- Do not touch the fixture head, shade or lamp shield while
the fixture is on. These surfaces may be VERY HOT.
- Do not touch lamp at anytime. Use a soft cloth instead as oil
from skin may damage lamp.
- It is normal for a new halogen lamp to produce minor
smoke when first turned on.
- Turn power off and allow to cool before replacing lamp.
B
H
CANOPY
4: Determine the desired fixture height (H), from the bottom of
the fixture frame to the top the canopy and standoffs.
FIXTURE FRAME
A
SUPPORT CLIP
FIXTURE
FRAME
1: Carefully slide the four wire covers on top of the fixture
towards the center of the fixture frame.
2: Insert the curved end of the support clip to the bottom
slot of the fixture frame and then squeeze the other end to
safely secure into the bottom slot.
3: Install the remaining support clip to each corner of the
fixture frame, and slide wire covers back in place.
SUPPORT
CLIP
FIXTURE
FRAME
3
4
WIRE COVER
ELECTRICAL BOX
C
CROSSBAR
5: Feed the power wires through the crossbar center cutout.
6: Secure the crossbar to the electrical box with the provided
two #8-32 screws.
5
6
6
#8-32 SCREW
NOTE: The fixture must be mounted within 3ft of the electrical
box.
1
BOTTOM
SLOT
STANDOFF
3
3