Cooper Instruments & Systems Model 7i Professional Force/Torque Indicator - Manual (Page 39)

Model 7i Digital Force / Torque Indicator User’s Guide
38
17.5 Initial settings
This section is used to configure the initial settings upon powering on the indicator. The initial units of
measurement and the primary reading measurement mode may be configured. To access these settings,
select Initial Settings from the menu. The screen appears as follows:
17.6 Restore Default Settings
Default factory settings can be restored by selecting Restore Defaults from the menu. The settings may
be found in the Specifications section. The screen appears as follows:
17.7 Information / Welcome Screen
The following screen is displayed at power-up and can be accessed at any time by selecting Information
from the menu:
RESTORE DEFAULT
SETTINGS?
No
Yes
Digital Indicator
Model M7i
Ind. SN: 1234567
Sensor: MR51-50
Sensor SN: 9876543
Version: 1.0
INITIAL SETTINGS
Units
lbF
Mode
Real Time
TONES
Keys
* Alerts
Set Points
* Momentary
Continuous