Bio-Rad CHEF Mapper® XA System - Manual (Page 41)

3. Select Multi State from the Program menu. The following screen will appear.
The Multi State data screen allows entry of the number of blocks and states within blocks.
Enter the number of blocks in the Number of Blocks edit field. Enter the number of states per
block in the States For edit fields. Press OK to continue. Press Cancel to return to the file
menu screen.
Enter the values for the run time, initial and final switch time, voltage gradient, angle,
and ramping factor.
Note: See Section 4.5 for the run parameter limits.
Multi state mode allows an interrupt to be entered in each block of the program. To enter
an interrupt, click Enable Interrupt, and enter the duration, time between interrupts, voltage
gradient, and angle. To implement the interrupts in a state, press Activate Interrupt in each
state the interrupt is to be used. See Section 9.3 for interrupt parameters and strategies.
Print
To print the Algorithm Input and Program Output screens, use the Report file in the
Print menu.
37