Bio-Rad CHEF Mapper® XA System User Manual

Page 40

Program

The CHEF Mapper algorithm allows run parameter entries into FIGE, two state, and multi

state modes. This section of the manual describes programming the CHEF Mapper system.

1. Choose Program from the file menu. Select FIGE from the Program menu. The

following screen will appear.

Enter the values for run time, forward and reverse switch times, voltage gradients, and

ramping factors in the appropriate edit fields.

Note: See Section 4.3 for the run parameter limits. Always enter values within the limits.

2. Select Two State from the Program file menu. The following screen will appear.

Enter the values for run time, initial and final switch time, voltage gradient, included

angle, and ramping factor.

Note: See Section 4.4 for the run parameter limits.