Bio-Rad CHEF Mapper® XA System - Manual (Page 28)

If 0 is entered, the screen will request another block.
Continue with another Block?: For another block, press 1, then ENTER. If another block
is not desired, press 0, then ENTER. The system will display: A Program is in memory.
Please enter another command. The program that was just entered is in short term memo-
ry (RAM). If the CHEF Mapper system is turned off, the program will be lost. The following
program options are available:
Start Run: Press START RUN to begin. If power goes off during a run, the program is
saved and resumes when power is restored. When the run is completed, only the AC
power light will be on, and the screen will display the message Run is Completed. Press
1 to save, or 0 to clear it. To delete the program, press 0. To save the program, enter 1.
To store the program, press STORE PGM (Section 4.8).
Edit the Program: To check the program just entered for errors or to make corrections,
see Section 4.9.
Store Program: To store the program just entered so that it is available for future use, see
Section 4.8.
Delay Start: To enter a time delay before the run is started, see Section 4.7.
Remove Program and Set Up a New Program: To delete the program just entered,
press either AUTO ALGORITHM, FIGE, TWO STATE, or MULTI STATE. The mes-
sage You will destroy last Program - Go On? will appear. Choose 0 for no, 1 for yes,
or 2 to edit the program. Press 1, then ENTER, to delete the program. Entering 0 saves the
program.
When interrupts are desired, enter 1 at the opening screen.
The display will ask if the interrupts will be 180° from the vector (i.e., go in the opposite
direction the DNA is moving). If yes, enter 1. If you want to assign the angle of the inter-
rupts, press 0 for no.
Blk1 Runtim: Enter the total run time for Block 1, and press ENTER. The acceptable run time
range is 1 minute–999 hours. Enter the run time as one time unit, either hours or minutes.
When entering the run time, put in the numeric value, then press HOURS or MINUTES.
Program with Interrupts ? [ ]
Continue with another Block ? [ ]
24