Bio-Rad CHEF Mapper® XA System - Manual (Page 17)

Cursor Arrow Keys are used to scroll through display screens in the auto
algorithm and editing mode.
Number Key Pad is used to enter numeric values. The +/- key is used to
enter positive or negative angles in the multi state mode.
Lower is used only to decrease numeric values currently displayed in the
editing mode.
Raise is used only to increase numeric values currently displayed in the edit-
ing mode.
Kilobases (K-BASES) is used to enter size values in the auto algorithm
mode.
Megabases (M-BASES) is used to enter size values in the auto algorithm
mode.
Hours is used to enter run times, interrupt frequencies, interrupt lengths, ini-
tial switch times, and final switch times.
Minutes is used to enter run times, interrupt frequencies, interrupt lengths,
initial switch times, and final switch times.
Seconds is used to enter interrupt frequencies, interrupt lengths, initial switch
times, and final switch times.
Enter is used to enter values into memory, to scroll through the display
screens in the edit mode, and to exit from an active delay start mode.
Clear Entry (CLR ENTRY) clears the current entry when entering or edit-
ing numeric values, prior to pressing ENTER.
Clear Memory (CLR MEM) clears stored user programs (see Section 4.8).
13
CURSOR
0
1 2 3
4 5 6
7 8 9
+/-
.
LOWER
RAISE
K-BASES
M-BASES
HOURS
MINUTES
SECONDS
ENTER
CLR ENTRY
CLR MEM