Bio-Rad Gene Pulser MXcell™ Electroporation System - Manual (Page 36)

Screen Intensity Option
27
• Press Delete to remove the selected protocol from the list.
• At the screen prompt, press Yes to delete or No to return to the previous
screen.
Screen Intensity Option
Adjust the screen intensity when you cannot clearly see the screen. To change the screen
intensity, follow these instructions:
1. Select Screen Intensity from the HOME screen.
2. Adjust the screen intensity.
Press the up and down arrow keys to change the intensity of the screen and view the
results of the change:
Measurements Option
Open the Measurements screen to measure the sample resistance of the buffer in your
plate. Use this function to verify a buffer, or troubleshoot experimental results.
NOTE: To select the plate size rof measuring buffer resistance, you must access the
protocol set-up. Select the plate size, return to the
HOME screen and follow these
instructions:
1. Select the Measurements option from the HOME screen.
2. Enter a well ID to measure the resistance of the sample in that well.
Press the left and right arrow keys to select a well to measurement. Then press ENTER
to accept the selection, press ENTER to obtain the measurement.
Use ? to raise intensity
Use ? to lower intensity
Measurements
Well
ABCD4
Sample Resistance 150
Capacitance (µF) ----