B&G Network GPSplus - Manual (Page 48)

49
SELECTING NMEA OUTPUT SENTENCES
The setting allows the NMEA output sentences to be
selected as ON (transmitted) or OFF (not transmitted). It is
important that when interfacing with other NMEA devices
that the correct sentences are selected to ON. Initially all
sentences are OFF except RMB and RMC. Refer to
GPSPlus Interfacing for more information.
1. Press
the POS key.
2. Press the SETUP key until OUtPUt is displayed. The
NMEA sentence mnemonic will flash.
3. Use the ▼ STEP ▲ knob to view the list of NMEA
sentences and the current status (ON or OFF).
4. Press the ENTER key when the display shows the
required NMEA sentence mnemonic, ON or OFF will
now flash.
5. Use
the ▼ STEP ▲ knob to change the status.
6. Press
the ENTER key to memorise your setting.
NMEA CHECKSUMS
NMEA Output checksum: some older systems (e.g.
Hercules 390) do not accept this checksum data, so this
setup may need to be turned off.
1. Press
the POS key.
2. Press the SETUP key until C / SUMS is displayed. The
current status is displayed. The checksum is ON by
default.
3. Press
the ENTER key, the C / SUMS status ON/OFF will
now flash.
4. Use
the ▼ STEP ▲ knob to select the required status.
5. Press
the ENTER key to memorise your setting.
SEtUP
OUtPUt
APB - OFF
SEtUP
C / SUMS ON