B&G Network GPSplus - Manual (Page 15)

15
VIEWING THE WAYPOINT LIBRARY
Press the WPT/MOB key to the view the waypoint library.
If the WPT/MOB key was the last key that was pressed, the
display will show MARK## or MARKFULL for a few
moments.
The flashing number below the WPT legend indicates which
library location is being viewed (1 to 250). By turning the
▼ STEP ▲ knob the flashing number will change selecting
each waypoint library location in turn.
If the library location is empty nOt USEd will be displayed.
When a waypoint library location has been used the latitude
and longitude of the waypoint in displayed in degrees and
minutes. The waypoint "name" will be displayed to the left of
the WPT number. If it has no name then a number with a
leading "W" will be displayed e.g. W001.
ENTERING AND USING WAYPOINTS
The following pages describe how to use the many
waypoint functions in the order they are listed when the
SETUP key is pressed. The method of entering and
changing data is described in words and diagrams. These
will give you an indication of what you might expect to see.
B&G reserves the right to change the operation of the
instrument without prior notice, so variation may occur.
NOTES ABOUT ENTERING WAYPOINT DATA
• When a number or name is flashing the ▼ STEP ▲ knob
can be turned to alter the flashing display, without the
need to press any other keys.
• When in a SETUP mode, if a key has not been pressed
for a period of 30 seconds the SETUP sequence will be
exited automatically.
• The ▼ STEP ▲ knob increases values when turned
clockwise and decreases values when turned anti-
clockwise.
• To end any SETUP sequence and return to normal
operation, press any key except ENTER or the
▼ STEP ▲ knob.