B&G Network GPSplus User Manual
Page 38
39
INTRODUCTION TO SETUPS ON THE GPS
PLUS
The GPSPlus has many parameters that can be set if the
user wishes, some of these are alarms. The sequence for
adjusting or setting these parameters and alarms is similar
in every case, only the displayed information is different.
The SETUPs are arranged in a continuous list that you can
cycle through using the SETUP key. For a full description of
each SETUP with its selectable parameters please refer to
the table at the end of this section.
A short cut method allows you to start cycling through the
list from a different entry point determined by the POS
display. The following list illustrates this principle.
With this POS page
displayed the SETUP list
starts from INPUT
INPUT
AUTO ADV
RADIUS
ANCHOR AL
HDOP ALRM
CROSS TRK
ZONE # AL
DATUM
USER DATUM
With this POS page
displayed the SETUP list
starts from DISPLAY
DISPLAY
LOCAL TIM
DATE
With this POS page
displayed the SETUP list
starts from BEARINGS
BEARINGS
AUTO MAG VAR
DISTANCE
COG SOG
BEARINGS
LANGUAGE
With this POS page
displayed the SETUP list
starts from OUTPUT
OUTPUT
C / SUMS
TYPE
PRESENT POSITION
CONTRAST