B&G Network GPSplus User Manual
Page 44
45
CROSS TRACK ALARM
The Cross Track Error Alarm is triggered when the vessel
strays to the left or right of the course line drawn between
the last waypoint and the next waypoint in a route by more
than a preset distance, in other words, if the Cross Track
Error (XTE) value is larger than the value set.
SETTING THE CROSS TRACK ERROR (XTE) ALARM
1. Press
the
POS key.
2. Press
the
SETUP key until CrOSS trK is displayed.
3. Press
the
ENTER key, the display will flash the current
cross track error alarm limits.
4. Use
the
▼ STEP ▲ knob to alter the value in the range
0.01 to 9.99NM.
NOTE: The value is factory set to 1.00NM. The value
will be displayed in Statute Miles or Kilometres if those
units have been selected.
5. Press
the
ENTER key to memorise your setting. The
display will now flash the current alarm state.
6. Use
the
▼ STEP ▲ knob to select ON or OFF.
NOTE: The waypoint zone alarm is factory set to OFF.
7. Press
the
ENTER key to memorise your setting.
To change the alarm state without adjusting the limits, miss
out step 4.
SEtUP
CrOSS trK
OFF