Field set-up checklists – Great Plains YP625PD Operator Manual User Manual
Page 37
Great Plains Manufacturing, Inc.
Operating Instructions
33
02/23/2011
401-754M
Field Set-Up Checklists
Use the following tables to develop a final checklist for
your tractor/planter configuration. Additional or fewer
steps may be necessary depending on tractor features,
planter options and planting accessories.
Mechanical Checklist (Hitching)
Page
Planter hitched
Safety chain secured to tractor
Parking jack stowed
Electrical Checklist
Page
Verify electrical hookups solid
Check seed monitor terminal and observe
any diagnostic messages
a
a. Refer to monitor manual.
Option: Verify that, when planter is
lowered, optional radar speed sensor is
pointed at ground, at an angle
approximately 35
° below horizontal.
b
b. Refer to sensor documentation.
Hydraulic System Checklist
Page
Check tractor hydraulic reservoir full
-
Inspect connections for leaks
-
Perform a raise and lower operation
Check fan speed and airflow direction
a
a. Operate fan briefly. Observe rotor blades spinning
toward exit port as fan slows to a stop.
Mechanical Checklist (post-Hitching)
Page
Raise planter.
Disengage transport locks
Front-to-rear level
Marker extension set
Marker disc angle set
Markers folded (unless already at start of
first planting row)
Air System Checklist
Page
Fan butterfly valve set
Seed loaded. Lids closed.
Meter shutters open to chart value
No air leaks (except from seed hoppers)
Hoses and tubing - no sags, no pinches
Check both manifold and sensor lines
Hoses fully connected to meters
Planter Meter Drive Checklist
Page
Check chain lubrication and slack
Calibrate speed sensor pulses with planter
lowered.
a
a. Refer to seed monitor manual.
Seeding: Set/check Range and
Transmission against rate chart
b
b. Refer to Seed and Fertilizer Rate manual.
Row Units Checklist
Page
Preset depth handles alike.
Preset down force springs alike, except in
tire tracks.
Check closing wheel alignment
Set press wheels alike, except in tracks.
Check action and contact of side depth
wheels
52
Check wheel scraper gaps (if installed)
Slide gates open