Great Plains YP625PD Operator Manual - Manual (Page 116)

112 YP625PD Table of Contents Index Great Plains Manufacturing, Inc.
401-754M Table of Contents Index 02/23/2011
3. Tilt up and unfold one marker.
Find the suggested initial marker Extension in the
table on this page.
Note: When using twin-row spacings, marker extensions
are different for left and right.
Refer to Figure 106 and Figure 107
4.
Measure out the Extension distance from each
outside end row unit (whether in use or not). Do not
measure to center of row pair or triplet.
5. Mark the ground at this point.
6. To adjust marker width, loosen nuts on U-bolts .
Move marker disk tube in or out to get the proper
adjustment. Tighten nuts .
7. Repeat steps 3 through 6 for the other side.
8. With the planter still lowered, drive forward a few feet
for each side.
9. Check the mark locations. Adjust to obtain the table
value.
Figure 107
Marker Extension Adjustment
25450
1
2
3
E
E
1 2
3
1
Spacing Rows Marker Extension
Used Used Left Right
110cm Triple All Rows 359.6 cm
110cm Single Center Rows 359.6 cm
110cm Twin Left Pairs 385.0 cm 334.2 cm
110cm Twin Right Pairs 334.2 cm 385.0 cm
55cm Single Outside Rows 359.6 cm