beautypg.com

Loading dry fertilizer, Suitable materials, System inspection – Great Plains YP625PD Operator Manual User Manual

Page 28: Hopper lid operation

background image

24

YP625PD

Table of Contents

Index

Great Plains Manufacturing, Inc.

401-754M

Table of Contents

Index

02/23/2011

Loading Dry Fertilizer

If fertilizer will not be applied, uncouple the fertilizer
meter shaft at the left end of the left hopper. Pin the
coupler clear of the shaft joint.

Loading fertilizer prior to transport is not recommended.
Although the meters are not turning during transport, it is
possible for some material to spill through the meters,
particularly on rough roads.

Suitable Materials
Use only dry granular fertilizer. Granules must flow freely,
and must have a maximum diameter smaller than 7 mm
(to avoid bridging clogs in the applicator tube outlets).

Agricultural Chemical Hazard:
Wear protective equipment suitable for the material to be used,
and the material previously dispensed from the hoppers. Avoid
contact with skin or eyes. Avoid breathing dust.

System Inspection
Verify that both rear cradle pins are installed on all
hoppers. See Figure 82 on page 76.

Refer to Figure 16
Remove the lid on each hopper and inspect for:

• residual fertilizer incompatible with next use

• contaminants

• debris that might clog the meter inlets

• trapped animals lost tools, etc.

If it is necessary to clean a hopper, see “Dry Fertilizer
Clean-Out
” on page 76.

Hopper Lid Operation

Refer to Figure 17 and Figure 19
To unlock the hopper lid, lift the rubber latches

out of

the metal keepers

.

Note: The keeper hardware

tends to snag under the

hopper lip. Pull the lid edge forward and lift.

Refer to Figure 18
To open the lid, lift the front edge up and slide the lid
back into a vertical position behind the hopper. The lid is
held by retaining straps

.

Figure 16

Empty 2- and 3-Outlet Hoppers

31866

1

Figure 17

Hopper Latch Open and Closed

31866

2

3

1

Figure 18

Hopper Lid Open

31865

4

5

2

3

4

5